West Yarmouth · Cape Cod
Tile of America provides custom shower tile installation, bathroom floor tile, kitchen tile, backsplashes, and professional tile work for homes throughout Cape Cod.
Every project begins with careful evaluation of the space, substrate, level, and installation requirements so the written scope reflects what the project actually needs.
Careful preparation, waterproofing, layout, and professional tile installation for Cape Cod homes.
Tile Work for Coastal Homes
West Yarmouth sits on Lewis Bay on Nantucket Sound, where older framing, moisture movement, seasonal conditions, and uneven substrates can affect how tile performs over time.
Tile of America evaluates the substrate, moisture conditions, finish height, and layout before installation so the finished surface is built around the actual conditions of the home.
Shower Tile
Shower assemblies built on Schluter Kerdi-Board with a bonded membrane over every seam, corner and curb. The barrier behind the tile does more work than the tile does.
Bathroom Tile
Floors, walls and tub surrounds. Levelness, framing deflection and finish height are read before quoting, because a floor that moves is what cracks grout later.
Floor Tile
Porcelain, ceramic and natural stone through kitchens, entries and living areas. Large-format tile needs a floor flat within a tight tolerance, so the substrate is corrected first.
Backsplash
Backsplashes and countertop surrounds set out before any tile is cut, so outlet and switch cutouts land where they should rather than where the tile happens to end.
Waterproofing
The pan, the curb and the corners are where a shower fails. Waterproof panel through the core, then a bonded membrane dressed over every joint above it.
Repair
Failed tile, thinset and backer out, and the substrate repaired rather than tiled over. The removal is where the real condition of the floor finally shows.
Heated Floors
Electric mat or cable under the tile, with the thermostat sited where you will actually use it. The build-up has to be planned against the doorway before anything is ordered.
Large Format
Large format spans further, so any dip in the floor shows as lippage at the edges. Flatness is measured to the tolerance the format needs, not estimated by eye.
Niches & Benches
A niche and a bench are both holes in the waterproofing until they are detailed properly. Both are framed, sloped and membraned before any tile goes near them.
Curbless
A flush entry means the floor structure is recessed and the fall is built into the pan. It is a framing job before it is a tiling job, and it is settled on site.
Mosaic
Hexagon, penny round and glass accent work, where the layout and the grout joint decide the result. Set out dry before anything is fixed so the cuts land where they should.
Tile showers fail primarily because of waterproofing and subfloor failures, not because of the tile itself. Older framing can flex under load, stressing the bond layer and cracking grout. Salt air and moisture moving through crawlspaces accelerate failure wherever movement creates a gap.
Prevention begins with a waterproof substrate and a floor structure assessed and leveled before installation. Tile of America uses waterproof board systems, seals seams and connections, and adds redundant protection in wet-area assemblies.
Tile-only work without structural changes, plumbing relocation, or a change of use typically does not require a permit in many Massachusetts municipalities. A shower replacement involving a moved drain, altered wall, or other regulated work may require one.
Your town's building department determines the requirement for the specific project. Properties in or near a local historic district, and anywhere north of Route 6 between Sandwich and Orleans, should also confirm requirements when structural demolition is involved.
Most tile bids look similar at the top line. The difference is what is built under the tile. Substrate choice determines whether an installation remains flat, bonded, and watertight over time.
The substrate is not the majority of the budget, but it separates a lasting installation from one that fails early.
A foam-core panel with bonded waterproofing fleece, waterproof through the board itself rather than dependent on cement board behind a surface coating.
Premium wet-area systemThe panel is waterproof through its core, and a bonded Kerdi membrane goes over the seams, corners and curb on top of it, suited to assemblies where its geometry or attachment method is the better fit.
Waterproof through the panelDeflection, levelness, framing bellies, self-leveling needs, and finish height are assessed before the first panel is installed.
Quoted after site reviewTile of America provides a one-year written warranty on every installation in West Yarmouth and across Cape Cod. Covered workmanship issues are repaired at no charge, with no inspection fee. The warranty is provided in writing before work begins.
Tile of America is based at 15 Adams Rd in West Yarmouth and takes on tile work throughout Barnstable County, from the Upper Cape to the Outer Cape, plus selected projects toward Plymouth.
West Yarmouth · Cape Cod · Massachusetts
Clear answers about tile installation, repairs, preparation, service areas, finishing standards, and licensing across Cape Cod.
The cost of a tile installation on Cape Cod depends on the size of the space, the condition of the existing subfloor, how much leveling the structure requires, and the materials selected. Tile of America assesses the floor framing and finish-height requirements before quoting, because what is underneath the tile affects the scope as much as the tile itself. Contact Tile of America for a free estimate.
Tile of America evaluates whether hollow or cracked tile signals a surface problem or a substrate failure underneath. If the waterproofing layer behind the wall has been compromised, repairing individual tiles leaves the underlying failure in place and the problem recurs. A full replacement becomes the honest answer when the substrate cannot be made sound without opening the wall.
Tile of America inspects the subfloor and framing before work begins, so clearing the bathroom of personal items and providing unobstructed access to the floor and walls is the most useful preparation. If the home has hardwood flooring adjacent to the tiled room, noting the finish height of that floor helps the installer set the tile so the transition lands flush without a threshold strip.
Most homes in West Yarmouth were built between 1940 and 1999, and older framing in that range commonly shows bellies, out-of-level floors, and subfloor conditions that require correction before any tile is set. Tile of America checks the structure before quoting so that subfloor work is priced into the job from the start, not discovered after demolition.
Tile of America serves the full length of Cape Cod from West Yarmouth, including Provincetown, Truro, Wellfleet, Eastham, Orleans, Chatham, Brewster, Harwich, Dennis, Hyannis, Falmouth, Mashpee, Bourne, and Sandwich, as well as Plymouth to the north. Contact Tile of America to confirm scheduling for your town.
Every tile Tile of America sets goes in with leveling clips, so there is no lippage across the finished surface. In shower and wet-area installations, the company builds on Schluter Kerdi-Board panels that are waterproof through the board itself, seals every seam and connection, and adds a liquid membrane beneath the full Schluter Kerdi system as a second independent waterproofing layer.
Tile of America holds Massachusetts Home Improvement Contractor license HIC 220711. Marco Aurelio is the owner of record. The license can be verified through the state before work begins.
If you are still deciding which rooms, materials, or subfloor work the project needs, that is the right stage to reach out. Tile of America assesses the home before quoting, so the estimate reflects the actual installation conditions.
